Titan 0524032 Instruction Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4 © Titan Tool Inc. All rights reserved.
English
Maintenance
Use the following procedures to keep your HVLP spray system
running properly.
Cleaning / Replacing the Filters
IMPORTANT: Make sure the turbine is unplugged before
changing the filters.
1. Remove the lter covers on each side of the turbine by
turning them counterclockwise.
Filter cover
2. Remove each lter set (pre-lter and lter) from the lter
housing on each side of the turbine.
NOTE: Thewhitepleatedlterisremovedfromthe
turbineinthesamemannerastheltercover.
Turn counterclockwise to unlock and remove.
Pre-filter
Filter cover
White pleated filter
Pre-filter
Filter cover
Filter
3. Clean the lters. Either tap the lters to knock out the
contaminants or use pressurized air to blow out the
contaminants. For material that is not blown or knocked
loose easily, soak the lters in soapy water or mineral
spirits. Allow the lters to dry completely before placing
them back in the turbine.
NOTE: Donotusehighlyammablesolvents,suchas
lacquerthinner,tocleanthelters.
IMPORTANT: Do not soak paper pleated filter in solvents.
Only tap the filter or use compressed air directed at the
inside (the clean side)
4. Insert each lter back into its corresponding lter can.
NOTE: Makesurethewhitepleatedlteristted
securelytothespokesoftheltercan.Turn
clockwise to secure in place.
5. Replace the lter covers on each side of the turbine by
turning them clockwise.
After several cleanings, it may become necessary to replace the
lters. Refer to the parts list near the end of this manual for the
lter replacement kit part number.
Cleaning the Air Hoses
1. Periodically wipe the outer surface of the air hose with a
damp cloth to keep clean.
IMPORTANT: DO NOT submerge into or flush the air hose
with water or any chemical.
IMPORTANT: DO NOT use methylethylketon (MEK),
naphtha, mineral spirits, paint thinner, xylol/xylene, or toluel/
toluene to clean the air hose. Exposure over time could
cause damage to the hose.
IMPORTANT: Store indoors with the cord wrapped around
the handle.
Page view 3
1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments