Titan 0552071 Instruction Manual download pdf (Page 9)

NOTE: If the motor will not dislodge from the pump

housing:

  

  

of the motor crankshaft that extends through the

slider assembly.

12. With the motor removed, inspect the gears in the gear

box housing for damage or excessive wear. Replace the

gears, if necessary.

13. Install the new motor into the gear box housing.

NOTE: Rotate the motor fan manually until the armature

gear engages with the mating gear in the gear

box housing.

14. Secure the motor with the four motor mounting screws.

15. Push the new capacitors into their clip on the new motor.

16. Reconnect the wires (refer to the electrical schematic in

the Parts List section of this manual).

17. Slide the motor cover over the motor. Secure the motor

cover with the four motor cover screws.

Motor

Cover

Screw

Heat Sink

Assembly Screw

Heat Sink

Assembly

Fan

Shroud

Screw

Fan

Shroud

Brush

Cover

Relay

Relay Mounting

Screw

Motor

Mounting

Screw

Gear Box

Housing

Capacitors

Motor Cover

BLACK

RED

BLACK

RED

Replacing the Motor Brushes

Perform this procedure using Motor Brush Kit P/N 0508645.

1. Perform the Pressure Relief Procedure and unplug the

sprayer.

2. Loosen and remove the four motor cover screws.

Remove the motor cover.

3. Loosen and remove the two fan shroud screws. Remove

the fan shroud.

4. Using a small screwdriver, pry off the two plastic brush

covers.

5. Disconnect the black and red wires from the motor

brushes. Remove the motor brushes.

6. Install the new motor brushes and snap on the plastic

brush covers.

7. Reconnect the black and red wires from the motor brushes

(refer to the electrical schematic in the Parts List section of

this manual).

8. Position the fan shroud over the motor fan. Secure the

fan shroud with the two fan shroud screws.

9. Slide the motor cover over the motor. Secure the motor

cover with the four motor cover screws.

Replacing the Gears

1. Perform the Pressure Relief Procedure and unplug the

sprayer.

2. Loosen and remove the four motor cover screws.

Remove the motor cover.

3. Disconnect the black and red wires coming from the gear

box housing.

4. Loosen and remove the four motor mounting screws.

5. Pull the motor out of the gear box housing.

NOTE: If the motor will not dislodge from the pump

housing:

  

  

of the motor crankshaft that extends through the

slider assembly.

6. Inspect the armature gear on the end of the motor for

damage or excessive wear. If this gear is completely worn

out, replace the entire motor.

7. Remove and inspect the 2nd stage gear for damage or

excessive wear. Replace if necessary.

8. Remove and inspect the crankshaft/gear assembly for

damage or excessive wear. Replace if necessary.

9. Reassemble the pump by reversing the above steps.

During reassembly, make sure the thrust washers is in

place.

 



Front Cover

Gear Box Housing

Front Cover Screw

2nd Stage Gear

Thrust Washer

Motor Mounting

Screw

Crankshaft/Gear

Assembly

Armature Gear

Motor

Motor Cover

Motor Cover Screw

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Titan 0552071 Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Paint Sprayer Titan 0552071